A Smartphone stand was made by my 3D printer.

I made a "Smartphone stand". It's a my first product!

My current smartphone is Huawei G620s. The stand use for displaying and charging on the desk.

Design:
The smartphone 3D modelind data was created by 123D design into toppled on its side. Also printing out use Scoovo studio into toppled on its side.

Memorandum:
The working create 3D data is summary according to the follows.
   - Change view to TOP
   - Use sketch tools, select Polyline. Write a triangle.
   - Use sketch tools, select Offset. Make offset position in first triangle.
      These two triangle shape is base of smartphone stand.
   - Use construct tools, select Extrude and choice area of surrounding two triangle.
      And, input extruding Z axis size.
      You can see 3d triangle tube when move pan.
   - Also you can make smartphone put place then use sketch rectangle and construct extrude tools.
      I made two rectangle.
      One is put smartphones base side, more one is front side.
   - Made put place stick on smartphone base then use snap tool.
   - The stand cut three holes that use combine subtract tool.
      Holes are back panel center, front panel under and put place.
         Previous make subtract shapes and move appropriate position.
      These holes in order to pass through a USB cable.

Viewing is front and rear.

 

And it can use landscape.

3D Data File:
   STL File.
   THIS DATA FILE IS NO WARRANTY ANYTHING.

PrintingOut(Scoovo Studio):
That an object had done printing out it takes about 13 hours. (My 3D printer Scoovo C170 is too slow?)
G-code creating options are below.
   - Quality is Fine.
   - Support material is Existence.
   - Raft is None.

Improvement:
Running time is too long.
A one of the method, printing quality adjust to rough.
I'm thought that at first it should cut down raw materials to reduce running time. In short, back panel's and other holes expands diameter. In addition more unused walls make holes...